Supermicro Server 1U 8x 2.5" Bay X9DRH-7F 2x E5-2670 V2 32GB - 2208 RAID RAILS

•  Dual Intel® E5-2600 (V2) Series (Socket R) processors; each processor supports two full-width Intel
  QuickPath Interconnect (QPI) links (with support of
  up to 8.0 GT/s per QPI link)
  Note: For the E5-2600 V2 CPU to work properly,
  please update your BIOS to BIOS R3.0

•   Integrated memory controller supports up to
  1TB of 240-pin Registered (RDIMM)/Load Reduced (LRDIMM)/Non-Volatile (NVDIMM) ECC
  or Unbuffered (UDIMM) ECC/Non-ECC DDR3
  1866/1600/1333/1066/800 MHz memory in 16 slots
  (1866 MHz is not available on NVDIMMs.)
• Note : NVDIMM memory support is available on the X9DRH-iF & X9DRH-iF-NV only

• Intel® C602 (PCH)

• Three (3) PCI-E x8 slots (CPU1 Slots 1, 2, 3)
• Three (3) PCI-E x8 slots (CPU 2 Slots 5, 6, 7)
• One (1) PCI-E 3.0 x16 (CPU 2 Slot 4)

• Nuvoton BMC Video Controller (Matrix E200)

• One Intel I350/X540 10-Gigabit Ethernet Dual-Channel
  Controller for LAN1/LAN2 ports (GLAN Ports for -7F/-
  iF/-iF-NV; 10GLAN Ports for -7TF/-iTF)
•  Nuvoton WPCM 450 Baseboard Controller (BMC)
  supports IPMI_LAN 2.0

Two (2) I-SATA 3.0 (I-SATA
0/1),
Four (4) I-SATA 2.0 Ports
(I-SATA 2~5)

Four S-SATA 2.0 Ports 0~3
(From Storage Control Unit)

RAID 0, 1, 5, 10

RAID 0, 1, 5, 10

• 0~3, 4~7

• RAID 0, 1, 5, 6, 10, 50, 60 (Hardware RAID)

•  IPMI 2.0 supported by the Novuton BMC (WPCM450)

• Two (2) Fast UART 16550 Connection: 9-pin RS232 port

• Backplane VGA Port 1
• Front Panel Accessible VGA Port 2

•  Four (4) USB ports on the rear I/O panel (USB 0/1,
  2/3),
•  Four (4) USB connections for front access in two
  headers (USB 4/5, USB 8/9),
• One (1) Type A USB connections for front access
  (USB 6)

• 16 MB AMI BIOS® Flash EEPROM
• APM 1.2, DMI 2.3, PCI 2.3, ACPI 1.0/2.0/3.0, USB
  Keyboard, Plug & Play (PnP) and SMBIOS 2.3

•  ACPI/ACPM Power Management
• Main switch override mechanism
• Keyboard Wake-up from Soft-Off
• Power-on mode for AC power recovery
• Intel® Intelligent Power Node Manager (NM) (Available when the NMView utility is installed in the
  system)
• Manageability Engine (ME)

• Onboard voltage monitors for +1.8V, +3.3V, 3.3VSB,

+5V, +5V Standby, 12V, Memory, Chipset and Battery Voltage.

• CPU 5+1 -Phase switching voltage regulator
•  CPU/System overheat LED and control

• CPU Thermal Trip support
• Thermal Monitor 2 (TM2) support

•  Fan status monitoring with firmware 4-pin (Pulse
  Width Modulation) fan speed control
• Low noise fan speed control

• System/CPU Overheat LED
• Suspend-state LED
• UID/Remote UID LED